Pocket Pleaser Kit

Description

These kits contain parts taken from a single gun in most cases, however each kit is validated to be complete, so there may be some individual parts that are mixed and matched to make a kit complete.

These kits are all based on Ruger LCP Gen 1 – .380

In addition to being parts validated and complete, these kits include 1 Ruger Magazine, 1 Metal 3d printed rail block, as well as an upgraded recoil spring (11lb is stock, 13lb springs are believed to add life to the frame)

This is a premium kit and should contain everything you need to complete a Pocket Pleaser, short of filament. This kit DOES NOT CONTAIN the plastic frame that the LCP parts kits generally ship with, as it is not compatible with the pocket pleaser. The mag catch and spring has been removed from the frame and is also included with the kit.

All of these parts came from used guns. They show varying amount of wear. I don’t buy kits that look like they came out of a lake, but please don’t expect new parts (other than the recoil spring and rail block). Additionally, since these are used parts, its highly recommended to thoroughly clean everything before assembly.

Complete list of parts included below:

1. Slide
2. Barrel
3. Recoil Spring + Guide Rod
4. Hammer/Spring
5. Takedown Pin Detent ( bowtie)
6. Trigger Spring (small loop on one side, left side of pic)
7. Hammer Catch Spring (round in middle)
8. Hold open
9. Hammer Catch
10. Trigger Bar
11. Butt Plug
12. Takedown Pin (big head)
13. Hammer Spring seat pin (2 notches)
14. Hammer pivot pin (smooth, fatty)
15. Trigger pivot (fat bottom left)
16. Trigger
17. Hammer Catch pin(skinny in middle)
18. Trigger pin (small hat)
19. Hold open detent (fish hook)
20. Mag release and spring
21. Metal Rail